Send Message
Contact Us
Krystal

Phone Number : +86-13065023255

WhatsApp : +8613065023255

What should we pay attention to when transporting color coated plate?

November 14, 2022

Now there are more and more users want to buy color board. After the purchase of color coating board, what should we pay attention to when transporting? Let us know.

 

1. After the purchase of color coating board, special sling or soft sling should be used during loading and unloading. The product shall be shipped in the condition in which it was delivered. Vertical packing steel coil should also be kept vertical during transportation, loading and unloading.

 

2. The carriage of the transport vehicle shall be clean, the floor of the vehicle shall be laid with rubber pads or other protective devices, and necessary protective measures shall be taken around the carriage to prevent indentation or damage to the package.

 

3. Color coating plate shall not be pulled out, so as not to scratch the steel plate below when cutting burr.

 

4. Color coated products should be fixed firmly to avoid product damage or accidents caused by relative movement or rolling in the process of transportation

 

How much do you know about the application of color coated products? What substances should be kept away from when storing color coated products? Next, our staff will give you a simple explanation:

 

1. Color coated plate should be kept away from acid, alkali, salt, solvent and other corrosive substances during storage, transportation and use; Prevent rain and condensation, and do not soak in water or mud.

 

2. When transporting colored coated plates, thin film should be used to separate each layer to avoid relative sliding and scratches. For use in normal weather conditions, the slope of the coated sheet as roof shall not be less than 10 degrees.

 

3. The ambient temperature of color coating plate processing should be above 7℃; According to the thickness of the color coated plate, adjust the clearance of the processing roller system, the foreign matter on the roller surface and the supporting plate; At the same time, check whether the paint on both sides of the color coating board is peeling off. If the paint is chipping, the cause should be identified and action taken before proceeding.

 

Color coating plate bending: before processing should be stamping die, punch and other parts on the dirt and rust; The temperature in the processing process should be controlled above 5℃; During rolling, the roll should be made of hard materials (hardened steel, die steel, etc.) or coated with hard metal on the surface of the roll.

 

Color coating plate pressure processing: in the pressure processing, color coating plate must carefully choose its substrate and coating type; In addition, the color coating plate should be carefully processed, and the surface of the metal mold should be particularly smooth. According to the situation, the surface of the color coating plate should also be pasted with protective film to protect the coating.